|
|
Square Door,
Vacuum Inlet PVC
Low voltage inlet. There are two metal contact points inside the
hole of the valve. Either wire can be connected to either screw. Can be
installed to open up or down. Outer dimensions: 3 1/8" by 4 7/8"
|
|
|
|
Oval Door,
Vacuum Inlet PVC
Low voltage inlet. There
are two metal contact points inside the hole of the valve.
Can be installed to open up or down. Outer dimensions: 3 1/8" by 4 7/8".
|
|
|
|
Full
Face Vacuum Inlet PVC
Contains low voltage connections only. There
are two metal contact points inside the hole of the valve. Valves with two
holes on the face of the plate that are for 110 volt electricity are under
"Electric Valves".
Can be installed to open up or down. All rectangle valves on this page are
interchangeable. Outer dimensions: 3 1/8" by 4 7/8"
|
|
|
 
|
Oval
METAL Inlet
Contains low voltage connections only. There
are two metal contact points inside the hole of the valve. Metal inlets
are recommended for decoration, outdoors, or in the floor.
Can be installed to open up or down. All rectangle valves on this page are
interchangeable. Outer dimensions: 3 1/8" by 4 7/8".
|
|
|
Brass Chrome
|
Full Face, METAL
Inlet
Contains low voltage connections only. There
are two metal contact points inside the hole of the valve. Metal inlets
are recommended for decoration, outdoors, or in the floor. All rectangle
shaped valves on this page are interchangeable. Outer dimensions: 3
1/8" by 4 7/8".
|
|
|
3-in 1 Mounting
Bracket PVC
The most popular bracket for all Basic Inlet Covers. For new construction nail it to a stud. For existing home installation cut the stud side off and set it in a 2x4" drywall cutout. When piping, connect
ONLY a tight 90 or coupling to the flange. Finish it with a basic inlet valve cover.
|
|
|
|
Inlet Valve Extension Part#614
Use as many of these as needed when the wall,
for any reason, is too thick causing the mounting plate and finished plate
to not meet. Longer screws will be needed as well. It adds 3/4 of an inch
to the cover plate. If that is too much you can cut to size.
-
DIAMETERS:
- Large end inner is 1 5/8", outer is 1 7/8".
- Small end
inner is 1 1/2", outer is 1 5/8".
|
|
|
|
Exhaust Vent Door for Central Vacuum Pipe
Installed on the outside of the home to
exhaust the power unit. This is not needed with M.D.'s bag type units.
Fits 2" OD (Vacuum PVC Pipe). Overall size is 3-5/8"w X
4-5/8"h
|
|
|
|
Utility Valve with Contact Points Part#613A
Valve fits into PVC Vacuum Pipe Connectors
such as a coupling or 90-degree elbow (1 11/16 OD, and 1 3/8" ID).
The opening for the hose to go into is 1.5 inches ID, and the widest
diagonal section is 2.5 inches OD. Low voltage wire is ran from the valve
to the low voltage leads any central vacuum. Now the on/off switch on the
end of the vacuum hose will work!
|
|
|
|
Inlet Blank Cover Plate, White (3 in a pack)
Three cover plates come in one package. Use
the cover plate to cover up a old vacuum hole in the sheet rock or to gain
access into a wall.
|
|
Web Site Solutions